Sewing Data List - JUKI LBH-1790 Instruction Manual

13. Sewing data list
☆ Sewng data are those that can be nputted to 99 patterns from pattern  to 99 and can be nputted to
each pattern. The sewng machne has been set n the state that the data whch s necessary to set
"Wth/wthout edt" cannot be selected at the tme of your purchase. Change over the functon to "Wth
edt" f necessary for the use. / Refer to 12. Method of setting sewing data with/without edit.
No.
Sewing shape
S0
Ths tem selects the shape from among the sewng shapes of
30 dfferent knds whch the sewng machne has.
–
* Only 2 knds of standard sewng shapes can be selected
at the tme of your purchase. When ncreasng the knds of
shapes, perform settng of K04 Sewing shape selection
level of memory swtch data. / Refer to 21. Memory
switch list.
Cloth cut length
S02
Ths tem sets the length of cloth that s cut by cloth
cuttng knfe. However, n case of bar-tack shape (Nos.
27, 28, 29, and 30 of S0), sewng length s set.
By makng effectve U19 Function of plural
motions of cloth cutting knife of memory swtch
data, make the plural motons of knfe by the knfe
sze set n the tem U18 Cloth cutting knife size,
and the sewng product s cut. / Refer to 21.
Memory switch list.
Knife groove width, right
S03
Ths tem sets the clearance between cloth cuttng
knfe and rght parallel secton.
Knife groove width , left
S04
Ths tem sets the clearance between cloth cuttng
knfe and left parallel secton.
Overedging width, left
S05
Ths tem sets the overedgng wdth of left parallel
secton.
Ratio of right and left shapes
S06
Ths tem sets enlargement/reducton rato of rght
sde shape makng the knfe poston as the center.
Pitch at parallel section
S07
Ths tem sets sewng ptch of left and rght parallel
sectons.
2nd bar-tacking length
S08
Ths tem sets length of bar-tackng on the front sde.
Bottom Bottom of
of square straight
type bar-tacking
1st bar-tacking length
S09
Ths tem sets length of bar-tackng on the rear sde.
Top of
square
type
* 1 : Displayed according to the shape
* 2 : Displayed when it is set to with edit. Refer to 12. Method of setting sewing data with/without edit.
* 3 : Displayed when the function is selected.
Item
Refer to @-3. Standard sewing
shape list.
Bottom
of taper
– 29 –
Settng range Edt unt
 to 30 
3.0 to 9.6 0.mm
-2.00 to 2.00 0.05mm
-2.00 to 2.00 0.05mm
0.0 to 5.00 0.05mm
50 to 50 %
0.200 to 2.500 0.025mm
0.2 to 5.0 0.mm
0.2 to 5.0 0.mm
Remarks
–
–
–
–
–
–
–
–
–