JUKI LBH-1790 Instruction Manual page 42

(2) Method of editing cycle data
1) Set the mode to input mode.
When the back-lght of LCD dsplay 1 shows the
nput mode n blue color, t s possble to nput
the cycle data. When the back-lght s the sewng
mode n green color, press READY key 2
change over to the nput mode.
2) Call cycle data No. to edit.
Press PATTERN No. key 7
selecton screen, and pattern No. B whch s
selected at present flashes on and off. Press
ITEM SELECTION key !0
whch have been regstered are changed over
and dsplayed n order. Cycle data No. and
contnuous sttchng data No. whch have been
regstered after the last regstered pattern No. are
dsplayed. Here, select the cycle data No. whch
you desre to sew.
3) Set cycle data to editing status.
Press DATA key 8
dsplay C appears. Pattern No. D whch s sewn
first flashes on and off. In this state, it is possible
to edt the data.
4) Select editing point.
Press ITEM SELECTION key !0
editing point moves in order and flashes on and off.
When movng the edtng pont up to the last data,
addtonal ndcaton pctograph
5) Change data of selected editing point.
Press DATA CHANGE key !1
edtng pont can be changed.
Pattern No. whch has been regstered s
dsplayed and t s possble to select.
In addton, press RESET key 3
pattern data of edtng pont can be deleted.
Repeat steps 4) and 5) to perform edtng data.
to
to call pattern
, and patterns
, and cycle data edtng
, and
s dsplayed.
and data of
, and the
3
2
C
7 8
– 40 –
1
D
!0
!1