JUKI LBH-1790 Instruction Manual page 9

(4) Installing the sewing machine main unit
2 -1 (rubber)
1
3
(5) Tilting the sewing machine head
WARNING :
When tilting/raising the sewing machine head, perform the work so as not to allow your fingers
to be caught in the machine. In addition, to avoid possible accidents caused by abrupt start of
the machine, turn OFF the power to the machine before starting the work.
1
WARNING :
To prevent possible accidents caused by
the fall of the sewing machine, perform the
work by two persons or more when the
machine is moved.
) Place hnge plates 1 and shaft bearngs 2 -
(rubber) and 2 -2 (metal) n two places on the
head base and fix the hinge plates to the ma-
chne head wth setscrews 3 n two places.
When the rubber hinge and metal fitting
hinge are installed in reverse order, it
is dangerous since the sewing machine
shakes when it is tilted. So, be careful.
2 -2
(metal)
When tltng the sewng machne head, tlt quetly
the sewng machne untl head support bar 1
comes n contact wth t.
1. Make sure that sewing machine head
support bar 1 is placed on the table
before tilting the sewing machine.
2. To protect fall-down, be sure to tilt
the sewing machine in a level place.
– 7 –