Using The Initial Value Pattern - JUKI LBH-1790 Instruction Manual

10. Using the initial value pattern
Ths sewng machne has the ntal value to perform the optmum sewng for the sewng shapes (30 shapes).
/ Refer to _. INITIAL VALUE DATA FOR EACH SHAPE TABLE.
When creatng sewng data newly, t s convenent to create t by copyng the ntal value pattern.
1) Set the mode to the input mode.
When the back-lght of LCD dsplay 1 shows
nput mode n blue color, t s possble to change
the pattern. When the back-lght shows the
sewng mode n green color, Press READY key
to change over to the nput mode.
2
2) Call initial value pattern.
Press PATTERN NO. key 7
selecton screen A s dsplayed.
Pattern No. B whch s selected at present
flashes on and off on the display. Press ITEM
SELECTION key
!0
pattern .
3) Select shape.
Press SHAPE key
!2
screen C s dsplayed. Shape D whch s selected
at present flashes on and off on the display.
Select shape D to sew wth DATA CHANGE key
. It s possble to select the shape from
!1
among 2 shapes at the tme of your purchase.
However, t s possble to select the shape from
among maxmum 30 shapes by ncreasng the
shape selecton level (K04).
/ Refer to 20. Method of changing memory
switch data.
4) Perform trial sewing.
Press READY key 2
sewng mode (back-lght of LCD dsplay 1 s
green). Then t s possble to perform sewng and
the selected shape can be sewn.
* Intal value pattern can edt the needle thread
tenson data only. However, t returns to the
ntal value when changng the shape or
performng re-call of the pattern. So, be careful.
5) Copy initial value pattern.
Copy the pattern whch has been selected and
confirmed through the steps above to the normal
pattern and use t.
Copyng procedure / Refer to 14. copying
sewing pattern.
, and pattern
to select ntal value
, and shape selecton
to set the mode to the
– 26 –
B
A
2
1
7
!2
2)
C
3)
D
!0 !1