JUKI LBH-1790 Instruction Manual page 19

No. NAME
LCD dsplay Varous data such as pattern No.,
1
shape, etc. are dsplayed.
READY key Press ths key when startng sewng.
2
Every tme ths key s pressed,
change-over of sewng ready set state
and data set state can be performed.
RESET key Press ths key when releasng error,
3
travellng the feed mechansm to ts
ntal poston, counter resettng, etc.
MODE key Press ths key when changng data of
4
the memory swtches.
PRESSER key Ths key lfts or lowers the presser. When
5
the presser goes up, the needle bar
travels to the orgn and when t comes
down, the needle bar travels to the rght.
WINDER key Ths key s pressed when performng
6
bobbn wndng.
PATTERN NO. key Ths key selects pattern No. dsplay.
7
DATA key Ths key selects data dsplay.
8
COUNTER key Thus key selects counter dsplay.
9
ITEM SELECTION Ths key selects pattern No., data
!0
key No., etc.
DATA CHANGE Ths key changes varous data.
!1
key
SHAPE key Ths key selects shape dsplay.
!2
THREAD TENSION AT Ths key selects thread tenson at
!3
PARALLEL SECTION key parallel secton dsplay.
THREAD TENSION AT Ths key selects thread tenson at
!4
BAR-TACKING SECTION bar-tackng secton dsplay.
key
PITCH key Ths key selects ptch of parallel
!5
secton.
FUNCTION No.
!6
!7
!8
!9
@0
@1
@2
@3
@4
@5
@6
@7
@8
@9
#0
– 7 –
NAME
OVEREDGING Ths key selects overedgng wdth
WIDTH key dsplay.
BAR-TACKING Ths key selects left sde of bar-
WIDTH, LEFT key tackng wdth compensaton dsplay.
BAR-TACKING Ths key selects rght sde of bar-
WIDTH, RIGHT tackng wdth compensaton dsplay.
key
CLOTH CUT Ths key selects cloth cut length dsplay.
LENGTH key
CLEARANCE key Ths key selects clearance dsplay.
KNIFE GROOVE Ths key selects knfe groove wdth,
WIDTH, RIGHT rght compensaton dsplay.
key
KNIFE GROOVE Ths key selects knfe groove wdth,
WIDTH, LEFT key left compensaton dsplay.
COPY key Press ths key when copyng pattern.
PRESSER Ths key selects presser type.
SELECTION key
FORWARD key Ths key makes the feed mechansm
travel forward sttch by sttch.
BACKWARD key Ths key makes the feed mechansm
travel backward sttch by sttch.
PATTERN Ths s a short cut key that pattern regstraton
REGISTRATION key s avalable. Regstraton of shortcut to settng
dsplay of an optonal pattern s possble. For
the settng procedure, see P.36.
PARAMETER Ths s a short cut key that parameter
REGISTRATION key regstraton s avalable. Regstraton of shortcut
to settng dsplay of an optonal pattern, sewng
parameter or adjustment data s possble. For
the settng procedure, see P.37.
Speed varable Speed ncreases when ths s lfted
resster upward and decreases when ths s
lowered downward.
LCDadjustment Lght and shade of LCD dsplay can
varable rsstor be adjusted.
FUNCTION