JUKI LBH-1790 Instruction Manual page 33

No.
1st clearance
S22
Ths tem sets the clearance between st bar-tackng
and knfe groove. Ths tem s appled to all shapes.
2nd clearance
S23
Ths tem sets the clearance between 2nd bar-tackng
and knfe groove.Ths tem s appled to all shapes.
Single/double stitching
S3
Ths tem selects sngle or double sttchng.
Single
stitching
Double stitching cross selection
S32
Ths tem selects overlappng sttchng or cross sttchng at the
needle entry of parallel secton when settng double sttchng.
: Double stitching
Compensation of double stitching width
S33
Ths tem sets amount to narrow overedgng wdth of
st cycle when settng double sttchng.
Number of times of basting
S34
Ths tem sets number of tmes of bastng.
: Without basting
Basting pitch
S35
Ths tem sets ptch at the tme of performng bastng.
Rolling length of basting
S36
Ths tem sets rollng length of needle thread when
performng bastng.
Rolling pitch of basting
S37
Ths tem sets rollng ptch of needle thread when
performng bastng.
Rolling width of basting
S38
Ths tem sets rollng wdth of needle thread when
performng bastng.
Lengthwise compensation of needle entry of basting
S39
Ths tem sets the amount to move needle entry
poston back and forth when performng bastng
more than two cycles.
Crosswise compensation of needle entry of basting
S40
Ths tem sets the amount to move needle entry
poston to the rght or left when performng bastng
more than two cycles.
Compensation of left side position of basting
S4
Ths tem sets the amount to move the sewng
reference poston of bastng from the center of left
overedgng to the rght or left.
Compensation of right side position of
S42
basting
Ths tem sets the amount to move the sewng
reference poston of bastng from the center of rght
overedgng to the rght or left.
Item
Double
stitching
: Cross stitching
: With basting
(Setting of number of times)
– 3 –
Settng range Edt unt
0.0 to 4.0 0.mm
0.0 to 4.0 0.mm
– –
– –
0.0 to 2.0 0.mm
0 to 9  tme
.0 to 5.0 0.mm
2.0 to 20.0 0.mm
0.2 to 5.0 0.mm
0.0 to 4.0 0.mm
0.0 to 2.5 0.mm
0.0 to .0 0.mm
-2.0 to 2.0 0.mm
-2.0 to 2.0 0.mm
Remarks
–
–
–
*3
*3
–
*3
*3
*3
*3
*2, *3
*3
*2, *3
*2, *3