JUKI LBH-1790 Instruction Manual page 40

(2) Method of editing continuous stitching data
1) Set the mode to the input mode.
When the back-lght of LCD dsplay 1 shows the
nput mode n blue color, t s possble to select
contnuous sttchng data. When the back-lght
shows the sewng mode n green color, press
READY key 2 to change over to the nput
mode.
2) Call continuous stitching data No. to edit.
Press PATTERN No. key 7
selecton screen, and pattern No. B whch s
selected at present flashes on and off. Press
ITEM SELECTION key !0
whch have been regstered are changed over and
dsplayed n order. Cycle data No. and contnuous
sttchng data No. whch have been regstered after
the last pattern No. are dsplayed. Here, select the
contnuous sttchng No. whch you desre to sew.
3) Set continuous stitching data to editing status.
Press DATA key 8
sewn first flashes on and off. In this state, it is possible to edit the data.
4) Select editing point.
Press ITEM SELECTION key !0
mount / pattern No. / jump feed amount" and flashes on and off. When moving the editing point up to
the last data, addtonal ndcaton pctograph
5) Change data of selected editing point.
Press DATA CHANGE key !1
When the edtng pont s at the pattern No. :
Pattern No. whch has been regstered s dsplayed and t s possble to select.
When the edtng pont s at the jump feed :
It s possble to edt numercal value wthn the range of ±20 mm. In addton, press RESET key 3
and the pattern data of edtng pont can be deleted.
Repeat steps 4) and 5) to perform edtng data.
* Input is completed by the steps above. For the continuous stitching, however, input all data
within the range of the presser size. Error message will be shown when the data exceeds the
range. Be sure to precisely input the presser size.
/ Refer to 4. Inputting presser type
to call pattern
, and patterns
, and contnuous sttchng data edtng dsplay C appears. Pattern No. D whch s
, and edtng pont moves n order of "pattern No. / jump feed
, and data of edtng pont can be changed.
2 3
C
D
7 8
s dsplayed.
– 38 –
1
!0
!1