JUKI LBH-1790 Instruction Manual page 35

No.
Lengthwise compensation of tie stitching
S65
at the start of sewing
Ths tem sets start poston of te sttchng n
lengthwse drecton at the start of sewng.
Crosswise compensation of tie stitching
S66
at the start of sewing
Ths tem sets start poston of te sttchng n
crosswse drecton at the start of sewng.
Tie stitching width at the end of sewing
S67
Ths tem sets te sttchng wdth at the end of
sewng.
Number of stitches of tie stitching at the
S68
end of sewing
Ths tem sets number of sttches of te sttchng at
the end of sewng.
Lengthwise compensation of tie stitching
S69
at the end of sewing
Ths tem sets start poston of te sttchng n
lengthwse drecton at the end of sewng.
Crosswise compensation of tie stitching at
S70
the end of sewing
Ths tem sets start poston of te sttchng n
crosswse drecton at the end of sewng.
Knife motion
S8
Ths tem sets "Wth/wthout moton" of normal cloth cuttng
knfe.
: Normal knife
motion OFF
Knife motion at 1st cycle of double stitching
S83
Ths tem sets "Wth/wthout moton" of cloth cuttng knfe at st
cycle when double sttchng s performed.
: Normal knife
motion OFF
Maximum speed limitation
S84
Ths tem sets max. speed lmtaton of the sewng
machne. The maxmum value of data edt s equal
to the number of revolutons of K07 Maximum
speed limitation of the memory swtch data.
/ Refer to 21. Memory switch list
Pitch of going
S86
Ths tem sets sewng ptch of gong sde of bar-
tackng shape (Shape Nos. 27, 28, 29 and 30 of S0).
Width of going
S87
Ths tem sets wdth of gong sde of bar-tackng
shape (Shape Nos. 27, 28, 29 and 30 of S0).
Pitch of coming
S88
Ths tem sets sewng ptch of comng sde of bar-
tackng shape (Shape Nos. 27, 28, 29 and 30 of S0).
Width of coming
S89
Ths tem sets wdth of comng sde of bar-tackng
shape (Shape Nos. 27, 28, 29 and 30 of S0).
Item
: Normal knife
motion ON
: Normal knife
motion ON
– 33 –
Settng range Edt unt
0.0 to 5.0 0.mm
0.0 to 2.0 0.mm
0. to .5 0.mm
0 to 8 
0.0 to 5.0 0.mm
0.0 to 2.0 0.mm
– –
– –
400 to 4200 00st/mn
0.200 to 2.500 0.025mm
0. to 0.0 0.05mm
0.200 to 2.500 0.025mm
0. to 0.0 0.05mm
Remarks
*2
*2
–
–
*2
*2
–
*2, *3
–
–
–
–
–