Start Sewing - JUKI HZL-F series Instruction Manual

Marking
Needle
thread
Start from here
4
Place the fabric under the presser foot.
Raise the presser foot, pass the needle thread through
the hole on the presser foot and pull it out sideways.
Place the fabric under the presser foot, align the
marking with the sewing-start point. Penetrate the
Hole on the
presser foot
needle into the fabric by turning the hand wheel and
lower the presser foot.
Sewing-
start point
5

Start sewing.

The machine will stop automatically after sewing the
buttonhole.
* If a buttonhole of the same size will be sewn
again, push the thread trimming button to trim
the threads and raise the presser foot.
Under this condition move to another point,
lower the presser foot and then start sewing.
* Do not change stitch length and/or zigzag width
during buttonholing. Otherwise this will cause
imbalanced stitches.
* If thread trimming button is pushed while
sewing buttonhole, the machine will stop and
will not complete the buttonhole.
* Depending on material to be sewn and weaving
direction of the material, there might be a slight
difference in zigzag widths between right and left
lines of buttonholes. Test sewing is recommended.
46
47