Needle Thread Preparation; Threading The Needle Thread; Automatic Needle Threader - JUKI HZL-F series Instruction Manual

Needle thread preparation

Attention Turn OFF the power switch
before winding the bobbin thread.

Threading the needle thread

4
1
Spool cap
Spool cap
Spool cap Large spool
Spool cap
Large spool
19
20
Turn OFF the power switch
before winding the bobbin thread.
3
Small spool
Small spool
2
5
* Align the marking at the
hand wheel with the one
on the machine body.
1
Lift the presser foot lifting lever.
2
Place a thread spool to the spool pin and
a spool cap onto the spool pin.
There are three types of the spool caps, large, medium
and small. Choose the size of spool cap according to
thread spool to be used.
Note:
Make sure to push the
needle to the top.
It is impossible to perform
stitching if the needle is not
correctly installed or a bent
needle is used. Pay close
attention as this will cause
machine malfunction.
* Use the needle: No.11-16
and the thread: No.30-90.
* When twin needle is used,
the automatic needle
threader can not be used.