Stopper pin
● Buttonhole clamping plate
Clamping plate
47
48
6
Unplug the sensor pin after sewing.
7
Ripper
Opening the buttonhole using a ripper.
[double bartack]
Pierce a stopper pin at the bartack and open the
buttonhole with a ripper. Be careful not to cut the
stitches.
Eyelet
punch
[Keyhole buttonhole]
Place a cardboard under the buttonhole and make a
hole with the eyelet punch. Then pierce a stopper pin
at the bartack and open the buttonhole with a ripper.
It will be easier to sew buttonholes on the thin fabrics
and/or near the overlapped sections, if the clamping
plate is used.
1. Attach the buttonhole presser foot to
the presser foot holder, with the
clamping plate together.
2. Place the fabric between the presser
foot and the clamping plate.
* You can remove the clamping plate by holding
Turn off the power switch before
Caution
setting the clamping plate.
.