Applique (1) - JUKI HZL-F series Instruction Manual

Applique (1)

Keep the needle inside the fabric
at the point of arrow and raise the
presser foot.
Pattern No. Direct 5
Manual buttonhole
Presser presser foot (I)
foot Open toe presser foot
(O)
F600 Only
The edge of the applique fabric is sewn with a compact
zigzag, so it is suitable for the applique of cut fabric.
1
2
3
* Usually center needle position is used for appliqué
stitches but right or left needle position can be used.
Changing needle position: Refer to page 81
Turn OFF the power switch
before replacing the presser
foot.
Cut the applique fabric at the finish
line, put it on the base fabric and fix it
temporarily.
It is recommended to use both-sided adhesive
interlining or the similar to fix the appliqué fabric on
the base fabric. Use the interlining to the edge of the
appliqué fabric.
Turn the hand wheel towards you and
start sewing along with the outer side of
the applique fabric.
When you start sewing, the machine will automatically
sew 3 lock stitches.
* When sewing steep angles, keep the needle inside
the fabric, raise the presser foot, change sewing
direction and sew slowly.
At the end of sewing, push the reverse
stitch button to sew lock stitches for 3~5
stitches.
Attention
64
65