Winding the bobbin thread
Thread guide
Spool
pin
A
Bobbin
winding shaft
Guide (with cutter)
Bobbin winding regulator
3
4
5
6
7
Cutter
* An exclusive motor is built-in for winding
bobbin so that you can wind bobbin at
any time.
1
Place the thread spool to the spool
pin.
2
Thread the guide A and then
thread the thread guide (guide in
the circle) for bobbin winding
Set the bobbin on the bobbin winding
shaft.
Wind the thread to the bobbin 4-5 times in
clockwise direction.
Put the thread end into the guide at the
bobbin winding shaft and pull it to the
right side to cut it.
Push the bobbin winding regulator
towards the bobbin to start winding the
bobbin.
* Be careful that the bobbin winding regulator
works as a switch.
When winding is finished, the shaft
stops automatically, the bobbin winding
regulator moves to right and return to the
original position.
Remove the bobbin from the bobbin
winding shaft and cut the thread by cutter.
* Bobbin winding will automatically stop even
while winding, when the winding speed is
reduced due to a load to the bobbin winding
motor caused by thread tangling.
16
17