JUKI HZL-F series Instruction Manual page 70

F600 Only
Stitch in ditch quilting
67 68
Pattern No. Direct 1
Edge sewing
Presser
foot
presser foot (R)
This is for quilting the edge of patchworks and appliqués.
The machine will sew the lower (thinner) side of the fabric
layers. As a result, the stitches will not be noticeable and
have an effect to make the design look three dimensional or
emphasized.
1
2
* If the desired points can not be sewn, adjust the
needle position.
Needle position change: refer to page 81
Use manual buttonhole presser foot (I) or the open toe
presser foot (O). Sew curves by lifting the presser foot and
changing the direction very often.
Also this can be done by free motion with the quilt presser
foot. (Refer to page 69.)
Put the top layer of fabric with patchwork
and/or appliqués, quilting cotton and
bottom layer of fabric together by pin or
basting stitches.
Put the guide of the presser foot along
with the crease and sew.
The needle enters behind the guide, so that the edge
of the crease can be sewn.
Curved concealed quilting
Attention
Turn OFF the power switch
before replacing the presser
foot.