Function of operational buttons
Needle up/down button
Thread trimming button
After sewing, press this button to trim both
threads automatically.
Notes for thread trimming:
1. Do not use thread thicker than No.30.
2. After trimming, the stitch can be done without pulling up bobbin thread.
3. When sewing again after thread trimming, if you pull up the bobbin thread again and place it underneath
the presser foot together with needle thread, you can avoid birds nest on the wrong side of the fabric.
4. Regularly clean the machine (refer to page 94), as dust in the area of the thread trimming unit may
cause malfunction.
7
When machine stops, press this button to change the needle
position. (When the needle is up, the needle moves down
and vise versa.)
* when a stitch pattern is not selected, needle does not
move downward but you can move the needle up.
Even when the presser foot is raised, be aware
that the needle moves up or downward.
Speed controller
While sewing, speed can be adjusted.
Reverse stitch button
While pressing this button, machine sews reverse
(lock stitch).
Start/stop button
When pressing this button, machine starts to sew slowly and then
up to the speed set by speed controller.
When pressing this button again, machine stops with needle at
its down position.
Color of button indicates machine status.
Green: Ready to start and/or while sewing
Red: Not ready to start (When it is pushed in red condition,
needle moves by one stitch.)
7