Quilting (Straight Stitch) - JUKI HZL-F series Instruction Manual

F600 / F400

Quilting (straight stitch)

Setscrew for
presser foot holder
Presser bar
Presser foot holder
Assembling point
Setscrew for presser foot
Pattern No. Direct 1, 4
Presser foot Walking foot (N)
Quilting is the process of sewing the top layer of fabric,
with quilting cotton in between and a bottom layer of fabric
underneath.
By using the walking foot, the machine feeds both top and
bottom fabrics together at the same time, so fabric shifting is
eliminated.
1
Actuating lever
2
Needle
clamp
3
* To further avoid fabric shifts, set the presser foot
pressure lower.
Adjustment of presser foot pressure: Refer to page 26
* If it is necessary to sew with the same distance, use
quilt guide.
Quilt guide: Refer to page 60
Turn OFF the power switch
before replacing the presser
foot.
Put top layer of fabric with patchwork and/or
appliqué, quilting cotton and bottom fabric
together by using pin or basting stitches.
Assemble the walking foot.
Raise the presser bar. Loosen the setscrew for presser
foot holder and remove the presser foot holder. (Refer
to page 13)
Set the actuating lever on the needle clamp and insert
the assembling point to the presser bar and tighten the
setscrew for presser foot.
Place your hands to both sides of the
presser foot and sew by pulling the
fabrics apart.
* Sew with slow to medium sewing speed.
Attention
68
69