Table of Contents
Advertisement
7-13. Destination of connection for input/output connectors
CAUTION : :
• To prevent personal injury caused by abrupt start of the sewing machine, carry out the work after
turning OFF the power switch and a lapse of 5 minutes or more.
• To prevent damage of device caused by maloperation and wrong specifications, be sure to
connect all the corresponding connectors to the specified places.
• To prevent personal injury caused by maloperation, be sure to lock the connector with lock.
• As for the details of handling respective devices, read carefully the Instruction Manuals supplied
with the devices before handling the devices.
Solenod valves and sensors used wth ASN690 are connected to the connectors nsde the control box as
described below: Connection state of the connectors can be checked by loosening front-cover fixation screws
A (at two locatons) and openng the front cover.
!6
1
1 CN30
Motor sgnal connector
2 CN43
Needle bar poston detector (for + V : Unused)
3 CN3
Machne head connector (unused)
4 CN33
Needle bar poston detector (for +5 V : Unused)
5 CN36
Connector for solenod valve (Refer to the Engneer's Manual for detals.)
6 CN37
Connector for solenod valve (Refer to the Engneer's Manual for detals.)
7 CN38
Connector for operaton panel (unused)
8 CN40
Expanson connector (Refer to the Engneer's Manual for detals.)
9 W,W,
Jumper for changng over optonal nput/output supply voltage
W3,W4
!0 CN50
Connector for solenod valve (Refer to the Engneer's Manual for detals.)
!1 CN5
Connector for sensor swtch (Refer to the Engneer's Manual for detals.)
!2 CN4
Connector for expanson board (unused)
!3 W5 to W8
Jumper for changng over CN5 nput
(unused: If the connecton s changed, the sgnal wll not nput properly.)
!4 CN39
Connector for pedal juncton cable
!5 CN0
Connector for startng pedal
!6 CN06
Connector for 3-pedal unt (optonal)
Front cover
A
!5
2
3
4
5
6 8
7
– 45 –
A
!2
!4
!0
9
!1
!3
Advertisement
Table of Contents
