Table of Contents
Advertisement
5. OPERATION
5-1. Sewing procedure
CAUTION :
• Never start the machine with the eye protector cover raised in order to prevent injury accidents
caused by the needle and the knife.
• The machine becomes hot when it is running continuously or after it has run, never touch the
sewing machine.
3
Fig. A
1
2
4
)
Press ON button 1 of the power swtch to turn
ON the power.
When the buzzer is kept beeping imme-
diately after turning ON the power, press
OFF button 2 on the sewing machine to
turn OFF the power since connection of
the cord or power voltage may be wrong.
Indication given after turning the power on
)
After the power to the machne s turned on, the
ndcaton shown below appears on the opera-
ton panel.
The setting item "SEM" flashes on and off.
The machine will not start as long as the lamp
flashes on and off. If this indication does not
appear on the operation panel, turn off the
power to the machine. If the machine head is
not selected correctly, the indication will not
appear on the operation panel.
Refer to the Engineer's Manual for details.
Never remove the cloth guide while the
machine is ready for sewing in order to
prevent accidents caused by abrupt start
of the machine.
3)
When 3 is pressed while it is flashing on and
off, the machne gets ready for sewng. Insert
the materal along the cloth gude from the drec-
ton of the arrow as shown n Fg. A.
When the materal s nserted on start sensor 4
located ths sde of the throat plate, the machne
starts runnng to perform sewng.
– 9 –
Advertisement
Table of Contents
