Table of Contents
Advertisement
5-2. Explanation of the operation panel
/
switch :
1
When this switch is pressed, flashing stops and the contents of setting are determined.
The machne enters the sewng mode under whch t can start. When the materal to be sewn s already
placed on the machne under the Automatc mode, E333 wll appear on the operaton panel. In ths case,
the machne s unable to enter the sewng mode. If the curve sensor s set effectve, the same phenom-
enon occurs when the materal s already placed on the machne (E334). If E334 s dsplayed, check
firstly the neighboring area of the sensor whether the material has been placed on the machine. (The
same phenomenon occurs when dust settles on the sensor. Check the neghborng area of the sensor
for dust.)
If the power to the machine is turned off before having taken the aforementioned procedure, the data
changed will not be stored in memory.
/
switch :
2
When this switch is pressed, changeable positions flash on and off.
By pressing the switch, flashing position shifts in the right direction.
Starting the machine is prohibited while the switch lamp is flashing on and off (setting mode). The opera-
tion level can be changed by keeping this switch held pressed for five seconds.
switch :
3
When ths swtch s pressed, the contents of the dsplay decrease.
switch :
4
When ths swtch s pressed, the contents of the dsplay ncrease.
Press
initial value.
5 Set item indication :
6 Set contents indication :
7 Material edge sensor indication : It lights up.
8 Automatic sewing indication :
1
2
Used for determining the contents of setting.
Used for changing the contents of setting.
Used for changing the contents of the selected display (flashing section).
Used for changing the contents of the selected display (flashing section).
switch 3 and
switch 4 simultaneously, and the set value will return to the
Abbreviation of the name of the set item selected is displayed.
Content of the set item selected is displayed.
It lights up.
5
6
3
4
– –
7
8
Advertisement
Table of Contents
