Hex Dump Mode; Print Mode Of Wireless Lan Setting - SATO CG2 Series Operator's Manual

3.9 HEX DUMP MODE

HEX Dump Mode allows you to print the contents of the receive buffer in a hexadecimal format. This feature
allows the data stream to be examined for errors and troubleshooting.
After selecting the HEX Dump Mode in Operation Setting Mode, restart the printer (refer to Section 3.5
Operation Setting Mode). The printer then awaits data feeds and when data arrives, it prints out the HEX
data continuously.
To exit the HEX Dump Mode, restart the printer by turning off the printer and then on again.

3.10 PRINT MODE OF WIRELESS LAN SETTING

This mode produces print-out for wireless LAN setting. This is only available when the optional wireless LAN
interface unit is connected to the printer.
Preparation:
Make sure the media or ribbon (if required) are properly loaded in the printer.
Procedures
1
While pressing
FEED/LINE button, press
POWER button.
2
Release POWER button
and keep holding
FEED/LINE button.
(The printer will cyclically
advance to next mode as long
FEED/LINE
as the
held down.)
3
Release FEED/LINE
button when ON LINE
(POWER) indicator
changes to blinking red
light.
4
Press FEED/LINE button
to start printing.
Press FEED/LINE button
to pause the test printing.
Press again to resume.
CG2 Series Operator Manual
Printer status
Printer start-up
User Test Print Mode.
Factory Test Print Mode
Operation Setting Mode.
Wireless LAN Setting Print Mode.
button is
Wireless LAN Setting
Print mode is activated
and then paused.
Wireless LAN Setting
Print start after initial feed
and print continuously.
Wireless LAN Setting
Print paused.
Section 3: Operation and Configuration
ON LINE (POWER) indicator
Solid red light
Solid green light
Solid red light
Blinking green light
Blinking red light
Blinking red light
Blinking green light
Solid green light
Blinking green light
Page 3-17