SATO CG2 Series Operator's Manual page 44

Section 3: Operation and Configuration
3.10 PRINT MODE OF WIRELESS LAN SETTING (cont'd)
Notes:
• If you missed the chance to release the FEED/LINE button in step 3 above, just keep holding the FEED/
LINE button and wait for the next cycle.
• If you released the FEED/LINE button at the wrong ON LINE (POWER) indicator, just turn off the power
and restart the procedure.
• The printer will continuously print the wireless LAN setting information until the FEED/LINE button is
pressed. The printing is paused and will resume printing if the FEED/LINE button is press again.
To terminate the Wireless LAN Setting Print mode
First, ensure that you have pressed the FEED/LINE button to pause the test printing, then press POWER to
turn off the printer.
3.10.1 Output Data of the Wireless LAN Settings
The output data of the Wireless LAN Settings shows the current settings of the printer.
These output data are printed in two parts, each with the printing area of 60mm [2.36"] (Width) x 80mm [3.15"]
(Pitch), Standard.
First print-out (Basic settings)
No.
1 Interface 1
2 WLAN Ver/Date
3 Buffer Type
4 Protocol
5 MAC Address
6 IP Address
7 Subnet Mask
8 Default Gateway
9 DHCP
10 RARP
11 W-LAN Mode
12 SSID
13 Channel
14 Security Mode
Page 3-18
Print Item
Interface 1(W-LAN)
WLAN module
F/W version, Creation date
Buffer type
Protocol
MAC address
IP address
Subnet mask
Default gateway
DHCP
RARP
Wireless LAN mode
SSID
Channel
Security type
Contents of the print data
WIRELESS LAN
**.** / YY.MM.DD
Multi
Driver(CYC)
Driver(ENQ)
Status3
**:**:**:**:**:**
000.000.000.000
~ 255.255.255.255
000.000.000.000
~ 255.255.255.255
000.000.000.000
~ 255.255.255.255
ON
OFF(Auto-IP)
OFF
OFF
ON
Ad hoc
Infrastructure(SSID)
1 to 32-chr string
1 to 11
OFF
WEP
WPA
WPA2
DynamicWEP
CG2 Series Operator Manual