Section 8: Appendix
8.6 BASE REFERENCE POINT (cont'd)
Cutter Mode
1mm
(0.04")
Print
reference
position
Cut reference
position
• When using the center hole tag,
the top of the tag hole becomes
the print reference position, and
1mm (0.04") before this point
becomes the cut reference
position. When the head
density is 8 dots/mm, specify
<A3>V+048H0. When the
head density is 12 dots/mm,
specify <A3>V+072H0 to
correct 6mm (0.23") in the print
reference position.
Dispensing Mode
1.5mm
(0.06")
Print
reference
position
Peel off
reference
position
Page 8-10
I-Mark
<A3>V0H0
<A3>V+048H0
I-Mark
Gap
1mm (0.04")
Print reference
position
Cut reference
position
Center-hole
1mm (0.04")
Print reference position
(before correction)
Cut reference position
6mm
(before correction)
(0.23")
Print reference position
(after correction)
Cut reference position
(after correction)
1mm
(0.04")
Gap
1.5mm (0.06")
Print reference
position
Peel off
reference
position
CG2 Series Operator Manual