Program Download Mode - SATO CG2 Series Operator's Manual

OPERATION SETTING MODE
3.5
Notes:
• Briefly press the FEED/LINE button to select the desired function, and then execute the selected function
by pressing and holding the FEED/LINE button for more than 3 seconds.
• When the desired interface is selected, this setting will be valid after you restart the printer.
• When HEX dump mode is selected, the printer will be set to this mode only once by restarting the printer.
• When download mode is selected, the printer will be reset automatically and it enters the desired
download mode.
• When the default setting mode is selected and executed, the printer will be set to default setting.
• Make sure that the function execution is complete (indicator: Solid green light) before turning off the printer.

3.6 PROGRAM DOWNLOAD MODE

In this mode, the printer is set to receive an application program from the host computer to download into its
memory. Remember to set the printer to the correct active interface to be used for the data transfer.
Status of printer in Program Download Mode
Start-up
No
Reception
from interface?
Yes
Reboot
command
reception?
No
No
Program data
reception?
Yes
Download
Download
completion
Reboot and start in normal mode
Test print
Online
CG2 Series Operator Manual
(cont'd)
Activation via operation
setting mode or download
command.
At the start of download
mode
Yes
Wait to receive data
Start receiving data/
Receiving data
Writing to flash ROM
At the time of download
completion
Printer turns off
Printer turns on again
Test printing
Section 3: Operation and Configuration
ON LINE (POWER) indicator responses
Off (while pressing FEED/LINE)
Change to solid red light after
release of FEED/LINE
(From step 5 of Operation
Setting Mode. )
Blinking green light
Blinking red light
Green→Red (Lights in turn)
Solid green light
Blinking green light
No light
Solid red light
Solid green light
Solid green light
Page 3-13