Default Setting Mode; Hex Dump Mode - SATO CG412DT Service Manual

Section 4: Operation and Configuration

4.8 DEFAULT SETTING MODE

When default setting mode is selected and executed in Operation Setting mode (refer to Section 4.5
Operation Setting Mode ), the printer will reset to the default setting (factory preset) as listed below.
No. Items to be reset
1 Offset (V, H)
2 Pitch Offset
3 Cut Offset
4 Dispensing Offset
5 Tear-Off Offset
6 Label Size
7 Print Speed
8 Print Darkness
9 Sensor Type
10 Paper End Search
11 Zero Slash
12 Proportional Pitch
13 Initial Feed
14 Auto Feed
15 Operation mode
16 Interface
*1. To be connected by Port1024 and Port1025 (2 port connections) or Port 9100 (1 port connection)

4.9 HEX DUMP MODE

HEX Dump Mode allows you to print the contents of the receive buffer in a hexadecimal format. This feature
allows the data stream to be examined for errors and troubleshooting.
After selecting the HEX Dump Mode in Operation Setting Mode, restart the printer (refer to Section 4.5
Operation Setting Mode ). The printer then awaits data feeds and when data arrives, it prints out the HEX
data continuously.
To exit the HEX Dump Mode, restart the printer by turning off the printer and then on again.
Page 4-18
Default value
Vertical = 0 dot, Horizontal = 0 dot
0 dot
0 dot
0 dot
0 dot
Pitch 896 dot x Width 832 dot [203 dpi]
Pitch 1344 dot x Width 1248 dot [305 dpi]
75 mm/sec (3 Inches/sec)
3A
Gap
Roll
Enabled
Enabled
Disabled
Disabled
Continuous - (No setting)
Tear Off - (No setting)
Cutter Mode 1 (Head position)
Dispenser Mode 1 (Head position)
RS-232C Baud rate=19200 bps, Protocol = Protocol for
driver
LAN Protocol for driver (ENQ response mode) *1
IEEE 1284 Protocol = Protocol for driver
USB Protocol = Protocol for driver
CG4 Series Service Manual