Hex Dump Mode - SATO CL4NX Operator's Manual

4 Operation and Configuration

Hex Dump Mode

Tools > HEX-Dump > Hex Dump Mode
Enable or disable the Hex Dump mode.
If you set the Hex Dump mode to Enabled, the printer prints the received
data and at the same time creates a file of the received data inside
"hexdump/".
When you return the setting to Disabled, you can check the file on the
screen.
Note
• If you set the Hex Dump mode to Enabled, the design of the Online/
Offline screen changes.
• You can save a maximum of ten received data files for each type of
interface. Depending on the file size, the number of files you can save
will be less than ten.
• The details of the files created inside "hexdump/" are as follows:
• BT00xx.bin: Received data through Bluetooth.
• LAN00xx.bin: Received data through LAN.
• LPT00xx.bin: Received data through IEEE1284.
• SCI00xx.bin: Received data through RS-232C.
• USB00xx.bin: Received data through USB.
Buffer Dump
Tools > HEX-Dump > Buffer Dump
Save the receive buffer data to the printer.
Available only if you have set to Disabled in the Hex Dump Mode menu.
Press the START (right soft) button on the startup screen to save the data
to the printer.
Save the receive buffer data to "buff/".
Note
• The data files of the receive buffer are created for each type of
interface.
• The details of the file created inside "buff/" are as follows:
• BT0001.bin: The contents of the receive buffer for Bluetooth.
• LAN0001.bin: The contents of the receive buffer for LAN.
• LPT0001.bin: The contents of the receive buffer for IEEE1284.
• SCI0001.bin: The contents of the receive buffer for RS-232C.
• USB0001.bin: The contents of the receive buffer for USB.
• If you perform the Buffer Dump again, the existing file will be
overwritten.
186
CL4NX/CL6NX Operator Manual