SATO CG2 Series Operator's Manual page 50

Section 3: Operation and Configuration
No. Category
27 LAN interface *2
28 Non-standard code
29
30 Download
31
*1. Available for USB+RS-232C specification only.
*2. Available for USB+LAN specification only.
*3. Use SATO port or Port 9100 when sending print request from the printer driver.
*4. The printer will restart in specified mode.
Page 3-24
Setting item
LAN mode
Nonstandard code
switching
Nonstandard code
setting
Firmware download
Reboot mode *4
Setting contents
Protocol for driver(STATUS4)Cyclic response *3
Protocol for driver(STATUS4)ENQ response *3
1 port connection/ENQ response(STATUS3)
Standard code/Nonstandard code
Nonstandard code settings for STX, ETX, ESC,
ENQ, CAN, NULL, OFFLINE
Download firmware from the host computer.
(1) Start up in program download mode
(Available in normal operation mode only)
(2) Start up in normal operation mode
(Available in program download mode only)
CG2 Series Operator Manual