8.6 BASE REFERENCE POINT
The base reference point is the point at which one determines the print and cut positions.
The base reference position differs, depending on the print mode or the label pitch sensor to be used.
Continuous Mode
Print
reference
position
• When using the center hole tag, the
top of the tag hole becomes the print
reference position. When the head
density is 8 dots/mm, specify
<A3>V+048H0. When the head
density is 12 dots/mm, specify
<A3>V+072H0 to correct 6mm in the
print reference position.
Tear off Mode
1.5mm
(0.06")
Print
reference
position
Tear off
reference
position
CG2 Series Operator Manual
I-Mark
<A3>V0H0
<A3>V+048H0
I-Mark
Section 8: Appendix
Gap
(Print reference
position)
Gap end
Gap start
Center-hole
Print reference
position
(before correction)
6mm
(0.23")
Print reference
position
(after correction)
Gap
1.5mm (0.06")
Print reference
position
Tear off
reference
position
Page 8-9