Operation Setting Mode - SATO CG2 Series Operator's Manual

3.4 FACTORY TEST PRINT MODE (cont'd)
Second print-out (Settings)
This setting information is similar to the first print-out in user test print mode. Refer to Section 3.3.1 Output
Data of the User Test Print for details.
Third print-out (Interface)
This interface information is similar to the third print-out in user test print mode. Refer to Section 3.3.1 Output
Data of the User Test Print for details.

3.5 OPERATION SETTING MODE

The operation setting mode enables further selection of the functions of the printer. These are:
• Program download mode
• Font download mode
• Default setting mode
• HEX dump mode
• USB/ Wireless LAN interface
• RS-232C/ LAN interface
• Keypad selection
Selection of the above operation setting modes are as shown below.
Procedures
1
While pressing
FEED/LINE button, press
POWER button
2
Release POWER button
and keep holding
FEED/LINE button.
3
Release FEED/LINE
button when ON LINE
(POWER) indicator
changes to blinking green
light.
CG2 Series Operator Manual
Printer status
Printer start-up
User Test Print Mode.
Factory Test Print Mode
Operation Setting Mode
(The printer will cyclically
advance to next mode as
long as the FEED/LINE
button is held down.)
Printer enters Opera-
tion Setting Mode.
Section 3: Operation and Configuration
ON LINE (POWER) indicator
Solid red light
Solid green light
Solid red light
Blinking green
light
Blinking green light
To be continued on the next page.
Page 3-11