Section 2: Installation
2.5 CONNECTIONS
This section explains the power cable and interface cable connection procedures.
2.5.1 Standard interface connection
CG2 Series printers have two types of Main PCBs, and each type of PCB is equipped with a different type of
interface to perform data communication with the host. These are described as follows.
1) Type 1: USB and RS232C on-board
2) Type 2: USB and LAN on-board
Connect only one type of interface cable from the printer to the host computer. Use the cable that is
compatible with the standard of the interface board as stated in Section 7: Interface Specifications. Make
sure the cable is correctly oriented.
Type1: USB and RS232C on-board
RS232C
LAN
USB
Caution
Never connect or disconnect interface cables (or use a switch box) with power applied to either the host
or printer. This may caused damage to the interface circuitry in the printer/ host and is not covered by
warranty.
2.5.2 To activate the connected interface
After connection, you need to configure the printer to operate on the connected interface.
1.
Please perform the procedures to set the appropriate interface mode as describe in Section 3.5
Operation Setting Mode.
2.
In step 4 of this procedure, briefly press the FEED/LINE button repeatedly to select the interface mode
according to your connection.
Connected Interface
ON LINE (POWER)
indications
Page 2-10
Type2: USB and LAN on-board
USB
Wireless LAN
Green –> Red (Blinks in turn)
Host
RS-232C
LAN
flashes green in a long interval
CG2 Series Operator Manual