Measures For Rfid Error (Optional) - SATO CG2 Series Operator's Manual

3.16 MEASURES FOR RFID ERROR (OPTIONAL)

The printer equipped with this feature only if the optional RFID kit is installed.
If the number of tag write/read failures exceeds the maximum retry counts specified in [RFID tag error ignore
counts] or [Retry counts], the printer will indicate an error with ON LINE (POWER) indicator blinking and it will
pause to wait for key entry.
To restart the print, refer to the following operations.
Open cover
Cover open error detected
ON LINE (POWER) indicator
Blinks red
Close cover
Enters Offline mode
ON LINE (POWER) indicator
Blinks green.
Briefly press the
FEED/LINE
button.*1
ON LINE (POWER)
indicator Lights green.
Printer enters Online
mode and starts reprint.
Notes:
• If an "RFID tag error" is detected, the tag will be voided and marked as a defected tag.
• After performing the initial feed by the FEED/LINE button, the reprint will be performed.*
CG2 Series Operator Manual
RFID error detected
ON LINE (POWER) indicator
Blinks red in the longest
interval
Pauses and waits for
key entry
Select
function
(1) Reprint
ON LINE (POWER)
indicator turns off
ON LINE (POWER)
indicator lights green.
Printer enters Online
mode and starts reprint.
Section 3: Operation and Configuration
Briefly pressing the FEED/LINE button will cause
printer to cycle through the following operations.
Reprint (1)
Cancel 1 item
print request (2)
JOB cancel
(Cancel print request
of all items) (3)
Press and hold the FEED/LINE
button for more than 3 seconds
to determine function
(2) Cancellation of 1
item print request
ON LINE (POWER)
indicator turns off
ON LINE (POWER)
indicator lights green.
Printer enters Online
mode and print the next
item.
ON LINE (POWER)
indicator
Blinks red in the
longest interval
lights red
Blinks red in long
interval
(3) JOB cancel
(Cancel all
items)
ON LINE (POWER)
indicator turns off
ON LINE (POWER)
indicator blinks green.
Printer enters Offline
mode after canceling JOB.
1
Page 3-27