SATO CG2 Series Operator's Manual page 38

Section 3: Operation and Configuration
OPERATION SETTING MODE
3.5
Procedures
4
Briefly press the
FEED/LINE button
repeatedly to select
different operation setting
mode cyclically.
Briefly press =
press more than 1 second
but less than 3 seconds
* Keypad selection is only
available for USB/RS-232C
board printer. If Keypad is
selected, even if the keypad
device is not connected,
other interfaces cannot be
activated.
5
When the desired mode is
selected, press the
FEED/LINE button for
more than 3 seconds until
the ON LINE (POWER)
indicator is turned off.
6
Press the POWER button to
turn off the printer, then press
again to turn it on.
(NOTE: This step is NOT
required for download mode.)
Page 3-12
(cont'd)
Printer status
Program Download
Mode
FEED/LINE
Font Download Mode
FEED/LINE
Default setting Mode
FEED/LINE
HEX Dump Mode
FEED/LINE
USB/ Wirless LAN
interface
FEED/LINE
RS-232C/ LAN
interface
FEED/LINE
Keypad is selected*
FEED/LINE
Confirmation of the
selected mode.
Completion of function
execution.
The selected mode will
be valid by restarting
the printer.
(For download mode selection, the printer will continue to complete
the downloading process. Refer to section 3.6 and 3.7 for details.)
ON LINE (POWER) indicator
Blinking green light
Solid red light
Blinking red light
Green→Red (Lights in turn)
Green→Red (Blinks in turn)
Flashes green in a long interval
Flashes red in a long interval
Off (while pressing FEED/LINE)
Changes to solid green light
after release of FEED/LINE
(except for download mode,
in which case it will change to
solid red light.).
CG2 Series Operator Manual