Table of Contents
Advertisement
(i)
LD Information Display
Information on LD bound in specified disk array is displayed below.
--- LD Information ---
LDN(h) Capacity RaidType Current Default FmtTime State
0000
8.3GB RAID5
0001
8.3GB RAID5
0002
8.3GB RAID5
0003
8.3GB RAID5
Each item is described below.
LDN:
LD number
Capacity:
LD capacity
Raidtype:
RAID type of LD
Current:
The Host Director number that has the current ownership of the LD will be displayed. When the
Cross Call mode of disk array is ON, two Host Director numbers will be displayed.
Default:
The Host Director number which has the initial ownership of LD will be displayed.
FmtTime:
Format Time for LD Binding Value will be displayed only for the LD under formatting. For LD
not under formatting, "---" will be displayed.
State:
LD operating status is displayed as one of the following.
ready:
attn.(reduce):
attn.(rebuilding):
attn.(copy back):
attn.(preventive copy): The progress ratio of Preventive Exchange Assignment is displayed.
attn.(unformatted):
attn.(formatting):
attn.(format-fail):
attn.(expanding):
attn.(expand-fail):
attn.:
fault:
fault(media error):
* When LD specified by "Select LD Information" does not exist, or when "All LD Information" is selected with
no LD bound in disk array, the following error message is displayed.
iSM11173:LD doesn't exist.
00/01
00
---
ready
00/01
00
---
ready
00/01
00
---
ready
00/01
00
0
attn(formatting)
All PDs configuring the LD are in normal status.
Displayed when fault PD has become separated. (reduced).
The progress ratio of data rebuilding is displayed.
The progress ratio of spare-copying in redundant status is displayed.
Unformatted
The progress ratio of formatting is displayed.
Error in formatting
The progress ratio of logic expansion is displayed.
Error in logic expansion
When two or more states overlap.
Function failure occurs.
Function failure occurs in plural PDs.
II-29
Chapter 4 Setting Commands
71%
Advertisement
Table of Contents
