NEC Storage Manager Configuration Setting Tool User's Manual page 38

Chapter 4 Setting Commands
(2) Confirming Execution of Setting Command
After all the parameters above are specified, the system displays the message below to ask the operator if the
setup command may be executed.
conf:rankbind> Command execute? (y | n) = y
- Key in "y" or "n" (otherwise, "Y" or "N").
- If "y" is selected, the command is executed. Depending on commands, the system asks the operator if the
command may be executed again. (See (3) "Reconfirming Execution of Setting Command".)
- If "n" is selected, the command is not executed, and the screen returns to the menu. Depending on commands,
the system asks the operator if the same command is executed repeatedly.
Setting Command".)
- After the command is executed, the execution result is displayed, and the screen returns to the menu.
Depending on commands, the system asks the operator if the same command is executed repeatedly. (See (5)
"Confirming Repetition of Setting Command".)
(3) Reconfirming Execution of Setting Command
After execution of the setup command is confirmed, the message below appears on the screen. Reconfirm
whether the command may be executed.
conf:rankunbind> Are you sure to execute the command? (y | n) = y
- Key in "y" or "n" (otherwise, "Y" or "N").
- If "y" is selected, the command is executed.
- If "n" is selected, the command is not executed, and the screen returns to the menu. Depending on commands,
the system asks the operator if the same command is executed repeatedly.
Setting Command".)
- After the command is executed, the execution result is displayed, and the screen returns to the menu.
Depending on the selected item, the system asks the operator if the same command is executed repeatedly.
(See (5) "Confirming Repetition of Setting Command".)
* For the items below, a warning message is displayed to ask the operator if the command may be executed again.
Rank Unbind, LD Unbind, Dynamic Capacity Expansion, LD Ownership Cross Call, Expand LUN, Error Log
Dump
(4) Execution Result of Setting Command
<Normal end>
When the command ends normally, the following message appears.
Command Completed Successfully!!
II-14
(See (5) "Confirming Repetition of
(See (5) "Confirming Repetition of