Table of Contents
Advertisement
(2) Select disk array and PDG
After the program starts, the following selection menu for disk array and PDG is displayed.
Disk Array Name
1. iS2000
Q. Quit Program
autobind> Disk Array Subsystem (1 | Q) = 1
1. PDG No.0
2. PDG No.1
autobind> PDG Number (1 - 2) = 1
Select the object of disk array and PDG on this screen.
Input the number of the disk array for setting, and input the PDG number according to a message.
- If the number indicated in parentheses ( ) is not specified, message "Illegal Number!!" appears.
If no object of disk array exists, the following messages are displayed.
iSM11162:Disk Array Subsystem which can be operated by this program
is not found.
Q. Quit Program
autobind> Disk Array Subsystem (Q) =
In the case shown above, terminate the program and check whether the iSM Server monitors the disk array, check
environmental definition, and check connection with disk array. Refer to the description part about operation in
the "NEC Storage Manager User's Manual" in accordance with your OS.
(3) Stop the Program
Select [Q. Quit Program] on the disk array selection menu to stop the program.
Serial Number
100000013
II-3
Chapter 4 Setting Commands
Advertisement
Table of Contents
