Table of Contents
Advertisement
Chapter 4 Setting Commands
- Rebuilding Time
Specify the maximum time for rebuilding the RANK. Rebuilding time can be specified in the range 0 to 24
hours. If 0 is specified, the RANK is rebuilt most quickly. However, specify a suitable value for Rebuilding
Time in consideration of the host I/O load. Rebuilding Time shows approximate time, and the actual
rebuilding does not always take exactly the specified time.
* Check the disk configuration by "0. View Current Settings" before setting Rebuilding Time.
(4) LD Bind
Select "4. LD Bind" from the menu and input parameter as follows to bind a LD.
<When Standard is selected>
LD Bind
conf:ldbind> Parameter Type : Standard or Custom (s | c) [s] = s
conf:ldbind> PDG No. (0 - 3) hex =
conf:ldbind> RANK No. (0 - 3f) hex =
conf:ldbind> LD Capacity (1 - 68118) MB =
iSM11321:System space of 2MB is added to LD, and LD is bound.
conf:ldbind> LD Capacity OK? (y | n) =
conf:ldbind> Number of LD (1 - 22706) [1] =
conf:ldbind> Format Time (0 - 24) [0] hour =
< When Custom is selected.>
LD Bind
conf:ldbind> Parameter Type : Standard or Custom (s | c) [s] = c
conf:ldbind> LDN (0 - 3ff) hex =
conf:ldbind> PDG No. (0 - 3) hex =
conf:ldbind> RANK No. (0 - 3f) hex =
conf:ldbind> RANK Start Block Address (0 - 850a000) hex =
conf:ldbind> LD Capacity (1 - 68118) MB =
iSM11321:System space of 2MB is added to LD, and LD is bound.
conf:ldbind> LD Capacity OK? (y | n) =
conf:ldbind> Format Time (0 - 24) [0] hour =
Each parameter is described below.
- LDN (only for Custom)
Input LDN that is to be bound.
- PDG No.
Input PD Group of RANK used in LD.
- RANK No.
Input RANK used in LD.
II-18
Advertisement
Table of Contents
