NEC Storage Manager Configuration Setting Tool User's Manual page 41

- PD List (only for Custom)
Input PDNs which are set in "Number of PDs". To select two or more commands, refer to Part II 4.2.3 (1)
"Selecting Command" of this manual.
* Check the disks configuration by "0. View Current Settings" before binding the RANK.
* Do not input xfh when PDN is input in PD List(only for Custom).
- Number of RANKs (only for Standard)
Input number of RANK that is to be bound. Only when "Standard" is selected, the software automatically
assigns the parameters to bind plural RANKs.
* RANK cannot be bound by inputting PD of another PDG.
(2) RANK Unbind
Select "2. RANK Unbind" from the menu and input parameter as follows to unbind RANK.
RANK Unbind
conf:rankunbind> PDG No. (0 - 3) hex =
conf:rankunbind> RANK No. (ex. 0,1,2,5-9,..,3f) hex =
Each parameter is described below.
- PDG No.
Input PDG number of RANK to be unbound.
- RANK No.
Input the number of RANK to be unbound. To select plural RANKs, refer to Part II 4.2.3 (1) "Selecting
Command" of this manual.
* Check the disk configuration by "0. View Current Settings" before unbind the RANK.
* Do not unbind RANK of another PDG at the same time.
* When an LD is built, the RANK cannot be unbound. Unbind the LD before unbinding the RANK.
(3) Change Rebuilding Time
Select "3. RANK Rebuilding" from the menu and input parameter as follows to set the Rebuilding Time.
RANK Rebuilding
conf:rebuildtime> PDG No. (0 - 3) hex =
conf:rebuildtime> RANK No. (ex. 0,1,2,5-9,..,3f) hex =
conf:rebuildtime> Rebuilding Time (0 - 24) hour =
Each parameter is described below.
- PDG No.
Input PDG number of RANK in which Rebuilding Time is changed.
- RANK No.
Set the RANK number in which Rebuilding Time is to be changed. To select plural RANKs, refer to Part II
4.2.3 (1) "Selecting Command" of this manual.
* Rebuilding Time cannot be changed for a RANK of another PDG.
II-17
Chapter 4 Setting Commands