Dial Plan For Ring Groups - Aastra AastraLink Pro 160 Administrator's Manual

Notes:
1. By default, incoming intercom calls are enabled for all IP phone models. If
2. The Icom hard key is applicable to the 480i and 480i CT only; all other
3. Remote office phones cannot receive paging calls.
• Paging group security - An optional Password allows the administrator to
establish an access PIN code that users are required to enter before sending a
call to a Paging group.
The default 660 all-phones have a permanently enabled password. This group
is the VoIP equivalent of the Overhead Paging port, (see Chapter 4,
"Configuring Overhead Paging"
configured for that feature.
Note: If the incoming "Barge-in" setting is disabled, or the incoming

Dial Plan for Ring Groups

AastraLink Pro 160 dialplan provides access to Ring Groups using the "65"
prefix.
When configuring Ring Groups using the WebUI, AastraLink automatically
prepends the "65" digits to the groups's extension, to create a virtual extension
number. For example, creating a Ring Group 300 will automatically prefix 65 so
that the dial plan entry becomes 65300.
For more information about dial plans and for a table of dial plan numbers, see
Chapter 4,
Note: All phones, including DECT handsets (420d) and FXS phones are
41-001190-02 Rev. 01, Rel. 1.2
required, an Administrator can enable outgoing intercom calls on all model
phones (except 51i).
model phones (except 51i) can be configured with an Icom softkey.
"Auto-Answer" is disabled on the phone, the page does not go to the
speakerphone.
Table 4-1 "AastraLink Pro 160 Dialplan"
supported for Ring Groups.
Configuring Aastra IP Phone Accounts
on page 4-49) and shares the password
on page
Configuring Groups
4-40).
3-39