Configuring Fxo Lines - Aastra AastraLink Pro 160 Administrator's Manual

Configuring FXO Lines

On the AastraLink Pro, you can configure individual FXO lines (up to 6 lines) for
which incoming calls are routed. The following table identifies the destinations
for which you can choose to route your incoming calls on each line.
FXO Line Destinations Description
Default
SLA (Shared Line
Appearance)
Operator
FXS A
FXS B
<extension number>
<phone number>
You can also specify the number of rings you want the destination phone to ring
before your phone transfers the incoming call.
Note: This feature also allows you to provision FXO lines regardless of the line
41-001190-02 Rev. 01, Rel. 1.2
Configuring AastraLink Pro 160 System and Network Parameters
Sends incoming calls according to the configured incoming
call route on the Auto-Attendant page.
Sends the incoming call to the Shared Line Appearance (SLA)
line shared by all users in a Ring Group.
Sends the incoming call to the Operator.
Sends the incoming call to the FXO Port A.
Sends the incoming call to the FXO Port B.
Sends the incoming call to the specified extension or phone
number.
state (i.e. even if there is no FXO line voltage) to enable for FXO loopback
door entry phone use.
Configuring Dial Plan Settings
4-57