What To Do After Restoring Factory Default Settings - Aastra AastraLink Pro 160 Administrator's Manual

AastraLink Pro 160 Administrator Guide
Restoring AastraLink Factory Default Settings
Factory Default Restoration Procedure
Step Action
2 Verify that the LED on the front of the device is flashing green, or flashing red.
3 Use the end of a paperclip to press and hold the reset switch.
The LED on the front panel flashes RED for 10 seconds, then changes to AMBER.
Release the reset switch when the LED is AMBER, the factory default will commence.
Note: Releasing the switch during flashing RED resets rather than factory-defaults the system.
The AastraLink begins reverting to its factory default settings. The process takes up to 30 seconds to
complete. During this process, all configuration information, voicemail, and other files stored on the
AastraLink are erased.
The AastraLink then begins its normal reboot process. The LED turns steady green as the device
performs internal hardware diagnostic tests. Once tests are complete, the LED flashes green,
indicating a successful reboot. The device is now up and running.

What To Do After Restoring Factory Default Settings

After restoring factory default settings on the AastraLink device, you must
re-register an IP phone with the device, and use it to specify initial startup
configuration parameters.
Note: The instructions in this section assume you have previously configured an
7-8
Administrator IP phone on your AastraLink network. Therefore, this
section does not describe initial IP phone setup or installation instructions.
For this type of information, see the AastraLink Administrator's QuickStart
Guide.
41-001190-02 Rev. 01, Rel. 1.2