Aastra AastraLink Pro 160 Administrator's Manual page 130

AastraLink Pro 160 Administrator Guide
Configuring System Settings
AastraLink Web UI
Step Action
7 Specify the decibels to use for power when Real Time Transport Protocol (RTP) is sent TO the line, in
the "RTP to Line Power (dB)" field. This gain parameter is used to adjust the outgoing audio levels
(for example, signal amplification or attenuation).
Valid range is +6 dB to –14 dB. Default is -3.
Note: Aastra recommends you DO NOT change the default setting for this parameter because of
FCC regulatory compliances.
8 Specify the decibels to use for power when Real Time Transport Protocol (RTP) is sent FROM the
line, in the "Line to RTP Power (dB)" field. This gain parameter is used to adjust the incoming audio
level (for example, signal amplification or attenuation).
Valid range is +6 dB to –14 dB. Default is 0.
Note: Aastra recommends you DO NOT change the default setting for this parameter because of
FCC regulatory compliances.
9 Click <Save> to save your changes.
4-20 41-001190-02 Rev. 01, Rel. 1.2