Erasing A Project; Changing The Project Name - Zoom MRS-1608 Operation Manual

Reference [Projects]

Erasing a project

This operation erases the specified project from the hard
disk.
1.
Refer to steps 1 – 2 of "Basic procedure" to
bring up the indication "PROJECT ERASE"
on the display. Then press the [ENTER] key.
PRJ ERS PRJ ERS
PRJ004 PRJ004
Project name
2.
Turn the dial to select the project, and press
the [ENTER] key.
The indication "PRJ ERS SURE?" appears on the
display.
3.
Press the [ENTER] key to erase the project.
When erasing is completed, press the [EXIT] key to
return to the main screen.
NOTE
• Once a project has been erased, it cannot be recovered. Use
this operation with care.
• A project for which protect is ON cannot be erased. Set
protect to OFF and then repeat the procedure.
• If you erase a project that is currently loaded, the lowest-
numbered project will automatically be loaded after the erase
operation has been completed.
168
PRJ 004 PRJ 004
Project number

Changing the project name

This operation lets you edit the name of the currently
loaded project.
1.
Refer to steps 1 – 2 of "Basic procedure" to
bring up the indication "PROJECT NAME"
on the display. Then press the [ENTER] key.
The current project name is shown on the display.
PRJ NAME PRJ NAME
PRJ003 PRJ003
2.
Use the cursor left/right keys to move the
flashing section to the character you want
to change, and turn the dial to select the
new character.
For information on available characters, refer to page 36.
To return to the main screen after editing the name, press
the [EXIT] key several times.
ZOOM MRS-1608