Table of Contents
Advertisement
Reference [Track Editing]
Reversing a specified range of
audio data
You can reverse the order of a specified range of audio
data.
Reverse
A
B
C
D
E
1.
Refer to steps 1 – 6 of "Basic steps for
range editing" to select the track/V-take for
reversing, and press the [ENTER] key.
The indication "Rvrs Src START" appears on the display.
Rvrs Src
Rvrs Src
START
START
0 0 0 0 0 0 0 001
2.
Use the cursor left/right keys to move the
flashing section of the counter, and turn the
dial to specify the reversing start point.
3.
Press the [ENTER] key.
The display indication changes to "Rvrs Src END".
Rvrs Src
Rvrs Src
END
END
0 1 118 18 0 0 042
4.
Use the same procedure as in step 2 to
specify the reversing end point.
R
If you press the PLAY [
be played.
5.
Press the [ENTER] key.
The indication "REVERSE SURE?" appears on the
display.
6.
To execute the reversing operation, press
the [ENTER] key.
When the reverse operation is completed, the unit returns
to the track edit menu.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
54
E
D
C
B
A
001 1 1 0 0 00 00
042 2 2 0 0 00 00
] key, the specified range will
Changing the duration of a
specified range of data
You can change the duration of the specified range of
audio data on a track without changing the pitch (time
stretch/compress). The stretched or compressed data can
be written over the old data on the same track or pasted
on another track while leaving the source data
unchanged.
Time stretch/compress
A
B
C
D
E
NOTE
• The editing start point for time stretch/compress is always
from the beginning of the V-take.
• The point where you stop playback when checking out the
time stretch/compress effect becomes the editing end point.
1.
Refer to steps 1 – 6 of "Basic steps for
range editing" to select the track/V-take for
time stretch/compress, and press the
[ENTER] key.
The indication "TmStrDst" appears on the display. In this
condition, you can select a track/V-take on which to place
the audio data after time stretch/compress.
TmStrDst
TmStrDst
TR 1- 1
TR 1- 1
2.
Use the cursor up/down keys and the dial
to select the destination track/V-take, and
press the [ENTER] key.
The display indication changes as follows.
TimStrch
TimStrch
100.00%
100.00%
Stretch ratio
This screen lets you specify the ratio for time stretch/
compress in two units, as listed below.
• Stretch ratio (%)
Expresses the length of the track after time stretch/
compress.
A B C D E
120.0
120.0
Tempo
ZOOM MRS-1608
Advertisement
Table of Contents
