Importing A Phrase From The Current Project - Zoom MRS-1608 Operation Manual

Importing a phrase from the
current project
You can specify a range from any track/V-take of the
current project and use it as a phrase.
1.
Refer to steps 1 – 6 of "Basic phrase
loading steps" to select "TAKE" as import
source. Then press the [ENTER] key.
The indication "ImprtSrc TRxx-yy" (where xx is the
track number and yy the V-take number) appears on the
display. In this condition, you can select the import
source.
2.
Use the dial or the status keys to select the
track, and use the cursor up/down keys to
select the V-take number.
ImprtSrc ImprtSrc
TR 16- 1 TR 16- 1
When track 16 is selected, turning the dial further to the
right selects tracks in odd-numbered/even-numbered
pairs or the master track. (Pressing two status keys for
odd/even-numbered tracks together selects the tracks as
two mono tracks.) When a stereo track, two mono tracks,
or the master track is selected, the phrase can be imported
in stereo.
HINT
By repeatedly pressing the status key of a stereo track, you
can select the odd-numbered track, even-numbered track,
and stereo track.
3.
Press the [ENTER] key.
The display indication changes to "ImprtSrc START". In
this condition, you can specify the start point for the data
range to be imported.
ImprtSrc ImprtSrc
START START
0 0 0 0 0 0 0 001
4.
Use the cursor left/right keys to move the
flashing section of the counter, and turn the
dial to specify the start point.
ZOOM MRS-1608
001 1 1 0 00 00
By moving the flashing section to the MEASURE/BEAT/
TICK or MARKER field on the display, you can specify
the point as a measure, beat, tick, or as a mark number.
HINT
• By holding down the STOP [
R
[ ] key, you can perform scrub playback of the V-take of
→
the specified track ( p. 38).
• The playback range of the phrase loop can be fine-tuned
also after importing.
Therefore it is best to choose a
somewhat wider range here.
• If you specify a point where there are no audio data, the
second line of the display shows
5.
Press the [ENTER] key.
The display indication changes as follows.
ImprtSrc ImprtSrc
END END
0 0 0 2 2 10 10 002
6.
Specify the end point of the range in the
same way as described in step 4.
R
If you press the PLAY [
be played.
7.
When you have fully specified the import
source, press the [ENTER] key.
The indication "IMPORT SURE?" appears on the
display.
IMPORT IMPORT
SURE? SURE?
8.
To carry out the import process, press the
[ENTER] key again.
The phrase is imported. When the import process is
completed, the phrase menu appears again.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
Reference [Phrase Looping]
P
] key and pressing the PLAY
symbol.
002 2 2 24 24 00 00
] key, the specified range will
69