Editing The Name Of A Send/Return Effect Patch; Importing Patches From Another Project - Zoom MRS-1608 Operation Manual

Editing the name of a send/return
effect patch
This section explains how to edit the name of the patch that
is currently selected for a send/return effect.
1.
Press the [REVERB] key or [CHORUS/DELAY]
key in the effect section, then use the PATCH
SELECT [W]/[Q] keys or the dial to select the
patch to edit.
2.
Press the [EDIT] key, and repeatedly press
the cursor down key to bring up the indication
"PAT NAME".
The name of the selected patch can now be edited. The
flashing character can be changed.
PAT NAME PAT NAME
DeepCho DeepCho
3.
Use the cursor left/right keys to move the
flashing section to the character to edit, and
turn the dial to select the new character.
For information on available characters, refer to page 36.
4.
Repeat step 3 as necessary to complete the
new name.
5.
To confirm the new name, press the [STORE]
key in the control section twice.
The patch is stored under the new name, and the send/return
effect patch select screen appears again.
ZOOM MRS-1608
Importing patches from another
project
If required, you can import all patches or specified patches
of the insert effect or send/return effect from another project
that is already saved on the hard disk.
NOTE
Keep in mind that importing patches in this way will overwrite
patches in the current project. Take care not to accidentally
erase patches that you wish to keep.
1.
Press the [UTILITY/TRACK EDIT] key to bring
up the indication "UTILITY IMPORT" on the
display, and then press the [ENTER] key.
The display indication changes as follows.
IMPORT IMPORT
ALL ALL
2.
Use the cursor left/right keys to select ALL
(import all patches) or PATCH (import a single
patch), and press the [ENTER] key.
In this condition, you can select the project from which to
import.
IMPORT IMPORT
PRJ005 PRJ005
3.
Turn the dial to select the import source
project, and press the [ENTER] key.
The subsequent steps differ, depending on which selection
was made in step 2.
● When ALL was selected
Verify that the indication "IMPORT SURE?" is shown on
the display, and proceed to step 5.
● When PATCH was selected
The import source patch appears on the display. Use the dial
and the [ALGORITHM]/[REVERB]/[CHORUS/DELAY]
keys to select the patch and press the [ENTER] key. You can
now select the import destination patch. Proceed to step 4.
Reference [Effects]
PRJ 005 PRJ 005
149