Loading A Project From Cd-R/Rw Disc - Zoom MRS-1608 Operation Manual

ALL SAVE ALL SAVE
SURE? SURE?
6.
To execute the backup, press the [ENTER]
key. To cancel, press the [EXIT] key instead.
When you press the [ENTER] key, backup starts from the
project with the lowest number. The display shows the
disc number, the project number, and the indication
"BURNING".
Disc number
DISC001 DISC001
BURNING BURNING
Project currently being saved
When the backup is finished, the display indication
changes to "ALL SAVE COMPLETE".
If the backup size is larger than the capacity of one CD-
R/RW disc, the disc will be ejected after it has been filled
up, and the display indication changes as follows.
CHANGE CHANGE
DISC002 DISC002
Number of project that has been only partly backed up
The right side of the display shows the number of the
project that has been only partly backed up. Insert the
next CD-R/RW disc and press the [ENTER] key. The
backup operation resumes. If more than two discs are
required, the above steps will be repeated.
NOTE
When a full backup spans several discs, restoring a single
project requires you to first insert the disc on which it is
saved. Be sure to note the disc number and the projects
saved on the disc on the case and label of the disc.
HINT
When the disc has been ejected, it is possible to abort the
backup operation. To do this, press the [EXIT] key while the
indication "CHANGE DISCxxx" (where xxx is the disc
number) is shown. The indication will change to "ALL SAVE
CANCEL?". Press the [ENTER] key to terminate the process.
ZOOM MRS-1608
PRJ 004 PRJ 004
PRJ 005 PRJ 005
7.
To return to the main screen, press the
[EXIT] key several times.
Loading a project from CD-R/RW
disc
To restore a project saved on CD-R/RW disc to the hard
disk of the MRS-1608, proceed as follows.
NOTE
Also when you have backed up all projects in a single
operation, restore is performed only for single projects.
1.
From the main screen, press the [CD-R/
RW] key in the control section.
The CD-R/RW menu appears.
2.
Use the cursor left/right keys to bring up
the indication "CD-R/RW BACKUP" on the
display, and press the [ENTER] key.
The display shows the indication "BACKUP SAVE".
3.
Use the cursor left/right keys to bring up
the indication "BACKUP LOAD" on the
display, and press the [ENTER] key.
The tray of the CD-R/RW drive opens and the display
indication changes as follows.
LOAD LOAD
InsDisc1 InsDisc1
4.
Insert the CD-R or CD-RW where the
project is saved into the CD-R/RW drive.
Insert the correct disc for the stored content.
●
If project was backed up as single project
Insert disc number 1.
●
If project was backed up as part of a full
backup of all projects
Insert the disc where the project is stored. (If there are
multiple discs, insert the first disc that contains data of the
desired project.)
Reference [Creating a CD]
163