Table of Contents
Advertisement
Reference [Effects]
2.
Use the PATCH SELECT [W]/[Q] keys or turn
the dial to select the patch.
The new patch is called up immediately.
HINT
The indication "EMPTY" appears instead of the patch name if
the patch is empty. Selecting such a patch will not have an
effect.
3.
To temporarily turn the insert effect off, press
the [BYPASS] key in the effect section.
The [BYPASS] key lights up, and the insert effect is
bypassed. Pressing the [BYPASS] key once more enables
the effect again.
4.
To return to the main screen, press the [EXIT]
key.
The flow of the signal that passes through the insert effect
will change as shown below, depending on the insert
location and the destination of the signal after passing the
effect.
● Using mono input insert effect on mono input/mono
track
● Using stereo input (or mono input x 2) insert effect on
mono input/mono track
142
● Using stereo input (or mono input x 2) insert effect on
stereo input/stereo track
● Using mono input insert effect on stereo input/stereo
track
● Sending insert effect output to stereo track or
[MASTER] fader
● Sending insert effect output to mono track
HINT
With the 8x COMP EQ algorithm, the 8 channel signals are
processed separately by the HPF/compressor and EQ effects.
Input and output for each channel therefore is always mono.
Editing the insert effect patches
The effect modules of the insert effect have various effect
parameters that can be adjusted to make detailed changes to
the character of the effect. By editing the effect parameters,
you can obtain the desired sonic result.
For some effect modules, you can also change the effect
type. For example the MODULATION/DELAY effect
module of the MIC algorithm provides 18 effect types such
as chorus, flanger, phaser, etc. (When you change the effect
ZOOM MRS-1608
Advertisement
Table of Contents
