Table of Contents
Advertisement
Reference [Track Editing]
NOTE
• You can also press the status keys for two adjacent odd/even-
numbered mono tracks together to select these tracks.
• Repeatedly pressing the status keys for stereo tracks selects
the odd-numbered track, even-numbered track, and stereo
track in sequence.
• When a single track has been selected as editing source for a
command other than HARMONY+ and DUO HARM, the
editing target will also be a single track.
• When two tracks or the master track have been selected as
editing source, the editing target will also be two tracks or the
master track. The currently selected V-take for each track will
be the target.
6.
Press the [ENTER] key.
The subsequent steps will differ, depending on which
command was selected. See the sections for the
respective commands.
7.
When the editing command has been
executed, repeatedly press the [EXIT] key
to return to the main screen.
NOTE
After executing an edit command for rewriting the audio data
on a track, the original data cannot be restored. To retain the
condition before editing, use the capture and swap functions
→
(
p. 65) for that track.
Copying a specified range of data
You can copy the audio data of a specified range to a
specified position on a specified track/V-take. This action
will overwrite the existing data at the destination
location. The copy source data will be unchanged.
Copy source track
Copy
Copy target track
1.
Refer to steps 1 – 6 of "Basic steps for
range editing" to select the copy source
track/V-take, and press the [ENTER] key.
The display indication changes as follows. In this
condition, you can specify the copy start point.
50
Copy Src
Copy Src
START
START
0 0 0 0 0 0 0 001
The edit range start point is shown on the counter in
hours, minutes, seconds, milliseconds, and in measures,
beats, and ticks.
2.
Use the cursor left/right keys to move the
flashing section of the counter, and turn the
dial to specify the copy start point.
The point can be specified in hours/minutes/seconds/
milliseconds, or in measures/beats/ticks. When a value is
specified, the other units also reflect the new location.
By causing a mark number to flash, you can also specify
edit points using the markers.
NOTE
If you specify a point where no audio data exist, the second
line of the display shows
3.
Press the [ENTER] key.
The display changes to "Copy Src END". This screen lets
you specify the copy range end point.
Copy Src
Copy Src
END
END
0 2 213 13 0 0 058
4.
Use the same procedure as in step 2 to
specify the copy range end point.
R
If you press the PLAY [
range will be played.
5.
Press the [ENTER] key.
The display now shows "Copy Dst TR xx-yy" (where xx
is the track number and yy the V-take number).
Copy Dst
Copy Dst
TR 1- 1
TR 1- 1
6.
Specify the copy destination track/V-take
in the same way as when selecting the copy
source, and press the [ENTER] key.
001 1 1 0 0 00 00
symbol.
058 3 3 0 0 00 00
] key at this point, the specified
ZOOM MRS-1608
Advertisement
Table of Contents
