Erasing A V-Take; Copying A V-Take - Zoom MRS-1608 Operation Manual

Reference [Track Editing]
HINT
Pressing the status key for a stereo track repeatedly selects
the odd-numbered track and even-numbered track in
sequence.
3.
Press the [UTILITY/TRACK EDIT] key in the
display section.
A menu for editing audio data in V-take units appears on
the display.
4.
Repeatedly press the [UTILITY/TRACK
EDIT] key to call up the desired command.
The following editing commands are
available.
• ERASE
Erase the audio data on a specified track/V-take.
• COPY
Copy the audio data of a specified track/V-take to another
track/V-take.
• MOVE
Move the audio data of a specified track/V-take to another
track/V-take.
• EXCHG (Exchange)
Exchange the audio data of a specified track/V-take with
the data of another track/V-take.
• IMPORT
Import any track/V-take from another project saved on
the hard disk.
HINT
If necessary, you can also change your selection of track and
V-take from this screen.
5.
Press the [ENTER] key.
The subsequent steps will differ, depending on which
command was selected in step 4. See the sections for the
respective commands.
6.
When the editing command has been
executed, repeatedly press the [EXIT] key
to return to the main screen.
NOTE
After executing an edit command for rewriting the audio data
on a track, the original data cannot be restored. To retain the
62
condition before editing, use the capture and swap functions
→
( p. 65) for that track.

Erasing a V-take

You can erase the audio data on a specified V-take. The V-
take is returned to the non-recorded condition.
1.
Refer to steps 1 – 5 of "Basic steps for V-
take editing" to select the track/V-take to
erase and to bring up the indication
"ERASE" on the display. Then press the
[ENTER] key.
The indication "ERASE SURE?" appears on the display.
2.
To execute the erase operation, press the
[ENTER] key once more.
When the erase operation is completed, the unit returns to
the V-take selection menu.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.

Copying a V-take

You can copy the audio data of a specified V-take to any
other V-take. This action will overwrite any existing data
on the destination V-take. The data on the copy source V-
take will be unchanged.
Copy source track
Copy
Copy target track
1.
Refer to steps 1 – 5 of "Basic steps for V-
take editing" to select the track/V-take to
copy and to bring up the indication "COPY"
on the display. Then press the [ENTER] key.
A screen for selecting the copy destination track/V-take
appears on the display.
Erase
ZOOM MRS-1608