Erasing A Specified Range Of Data; Trimming A Specified Range Of Data - Zoom MRS-1608 Operation Manual

Reference [Track Editing]
Erasing a specified range of data
You can erase the audio data of a specified range and
return the range to the non-recorded condition.
Erase
1.
Refer to steps 1 – 6 of "Basic steps for
range editing" to select the track/V-take for
erasing, and press the [ENTER] key.
The indication "Ers Src START" appears on the display.
Ers Src Ers Src
START START
0 0 0 0 0 0 0 001
2.
Use the cursor left/right keys to move the
flashing section of the counter, and turn the
dial to specify the erase start point.
3.
Press the [ENTER] key.
The display indication changes to "Ers Src END".
Ers Src Ers Src
END END
0 1 120 20 20 20 042
4.
Use the same procedure as in step 2 to
specify the erase range end point.
R
If you press the PLAY [
range will be played.
5.
Press the [ENTER] key.
The indication "ERASE SURE?" appears on the display.
6.
To execute the erase operation, press the
[ENTER] key.
When the erase operation is completed, the unit returns to
the track edit menu.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
52
001 1 1 0 0 00 00
042 4 4 24 24 00 00
] key at this point, the specified
Trimming a specified range of data
You can erase the audio data of a specified range and
adjust the data start/end point (trimming). For example,
when preparing to burn the master track onto a CD-R/RW
disc, you might want to remove unwanted portions at the
start and the end of the V-take that will be used.
Trim Trim
NOTE
When data before a specified section are erased (trimmed),
the remaining audio data will move up by that amount.
Therefore the timing may become mismatched with regard to
other tracks.
1.
Refer to "Basic steps for range editing" to
select the track/V-take from which you
want to trim data, and press the [ENTER]
key.
The indication "Trim Src START" appears on the display.
Trim Src Trim Src
START START
0 0 0 0 0 0 0 001
2.
Use the cursor left/right keys to move the
flashing section of the counter, and turn the
dial to specify the trimming range start
point.
All data before the point specified here will be erased.
3.
Press the [ENTER] key.
The display indication changes to "Trm Src END".
Trim Src Trim Src
END END
0 0 042 42230 230 032
4.
Specify the trimming end point using the
same procedure as in step 2.
All data after the point specified here will be erased.
R
If you press the PLAY [
001 1 1 0 0 00 00
032 4 4 12 12 00 00
] key, the specified range will
ZOOM MRS-1608