Applying The Insert Effect Only To The Monitor Signal - Zoom MRS-1608 Operation Manual

Reference [Effects]
Applying the insert effect only to
the monitor signal
Normally, when the insert effect is applied to the input
mixer, the signal processed by the effect will be recorded on
the track. If necessary, however, you can apply the insert
effect only to the monitor signal, and record the unprocessed
input signal on the track. For example when recording the
unprocessed sound of a vocal performance, the vocalist may
be more comfortable singing if an insert effect suitable for
mic recording is applied to the monitor signal.
INPUT
1.
Set the insert effect position to the input
mixer.
2.
At the main screen, press the [UTILITY/
TRACK EDIT] key in the display section.
The indication "UTILITY TR EDIT" appears on the display.
UTILITY UTILITY
TR EDIT TR EDIT
3.
Use the cursor left/right keys to bring up the
indication "UTILITY REC SRC" on the display,
and press the [ENTER] key.
The display indication changes as follows.
REC SRC REC SRC
WET WET
You can now select one of the following two signal types to
be recorded on the track.
● WET
The input signal that has passed through the insert effect will
be recorded on the track (default setting).
146
Insert effect
Recorder
● DRY
Only the unprocessed input signal will be recorded on the
track. Even in this case, however, the insert effect will be
applied to the signal appearing at the MASTER OUTPUT
jacks.
4.
Turn the dial to change the setting to "DRY".
5.
When you have finished adjusting settings,
press the [EXIT] key several times.
The unit returns to the main screen.
NOTE
The "UTILITY REC SRC" setting is stored for each project.
Before you begin recording other parts, be sure to change the
setting back to "WET".
ZOOM MRS-1608